XAT non-VVTi 1UZ Intake Manifold EGR Delete Cold Start Block Off Plates

SKU: 5-005

Please note due to draconian laws, we are not able to ship these to a California address. Please support the RPM act.

A simple, clean installation for your 1UZ swap! These blockoff plates are for the 89-97 1UZFE engines (LS400, SC400) and bolt on to the intake plenum. Get rid of all the stuff you're not using and clean up your build!

There's a few ways of deleting EGR from a non-VVTi setup. Our block off plate goes on the intake manifold itself. If you put it in between the intake manifold and the upper pipe, everything else can stay as it is. Otherwise you would ideally weld the header flange shut to stop any potential leaks there, and then you can remove the piping system entirely.

For off road vehicles ONLY. Made in the USA!

Vehicle Specific

Check if this part fits your vehicle.

Shipping info
We deliver worldwide
Learn more
Payment methods
Learn more

XAT-1UZn-IMB|OP |

- SKU
  5-005
- Weight
  1 lbs
- Dimensions (L x W x H)
  8 x 11 x 2 in
Manufacturer
XAT Racing
Engine Year Fitment
1989-1994, 1994.5-1997
Safety & Compliance
- Prop 65 Yes/No
  Yes

Most product ships from either the manufacture or largest wholesale location to pass the saving to you. Most orders will ship via UPS, as we will be able to provide the best rates and have had the least issues when using UPS.

IF YOU DO NOT LIKE THE AUTOMATED SHIPPING CALCULATOR'S RATES, PLEASE CONTACT US AND WE CAN GET YOU A BETTER ONE! Especially for anyone outside the USA, please contact us with a list of parts you'd like to order, and where you are located.

We accept the following payment methods:

Also Venmo and unmarked nonsequential dollar bills