In our continuing support of Lexus performance products and the UZ platform, we have finished this set of ZINC CHROMATED brackets to mount LS460 / LS600h or LS500 brake calipers to any GS300, GS400, GS430, SC430, and many others!
These brackets are ideal for those DIYers that are looking for an inexpensive option for brake upgrades. You keep your factory brake lines in this bolt-on solution; all you need is a set of front 2007-2018 LS460, LS460L, LS600h, or even the new 2019+ LS500 fixed 4 piston brake calipers, LS460 fitment pads, and a set of 2008-2014 IS-F 14" rotors!
Although the roll center adjusters aren't mandatory, they provide a bolt on solution. You do not have to run them, though if you do not, you may need to modify the mounting hardware. They will improve the suspension geometry on lowered cars at any rate, so we highly recommend them.
Please note that the LS460 does NOT use 5x114.3 rotors, so you will NOT be able to bolt on the LS460 rotor. We do not have fitment confirmation on the larger LS460 F-Sport 6 piston Brembo brakes, though they may also fit when used with larger rotors
Additionally, you will most likely need 18" wheels to fit over these. The only 18s we have found to not fit so far are some Enkei RPF1s. We cannot make any promises on what else will not fit, however every other 18" wheel we have tried does fit over these brakes.
☼ 1992-2005 Lexus GS300 / Toyota Aristo JZS147, JZS160, JZS161
☼ 1998-2000 Lexus GS400 / Toyota Aristo UZS160
☼ 2001-2005 Lexus GS430 / Toyota Aristo UZS161
☼ 2001-2005 Toyota Crown Majesta 1UZ
☼ 2001-2010 Lexus SC430 / Toyota Soarer UZZ40
☼ 1997-2017 Toyota Century V12 GZG50
☼ 1989-2000 Lexus LS400 / Toyota Celsior UCF10/UCF11 and UCF20/UCF21
You will receive 1 pair of brackets to mount both front calipers, as well as mounting hardware. Please note that we normally stock the brackets and rotors, however it may take 1 week to ship the calipers.
Pictures show the RWD K17 type caliper being used. The AWD N18 caliper has the same bolt pattern, but the caliper sits taller on the rotor. As such, the N18 version will not work with the IS-F rotor. You'll need to stick to the K17 type.
We have FINALLY released a rear kit to go along with this front kit! Our rear kit uses radial mounted LS430 (not LS460) rear calipers and Supra TT rear rotors. Check out the rear kit listing here! PLEASE NOTE FITMENT DIFFERS FROM THE FRONT KIT. NOT ALL OF THE ABOVE CHASSIS' ARE SUPPORTED. Keep in mind these are designed for off road use only and professional installation is required. We have been driving on these kits for years, but use at your own risk.